Standard Equipment

• NEMA 1 terminal housing
• Tubulars brazed to flange
• Fitted gasket
• Maximum 48 amp rating per circuit
• Heavy duty factory fitted jumpers
• 80/20 Nickel-chromium resistance wire
• High grade magnesium oxide insulation
• Factory fitted element spacers to prevent excessive rubbing (Only when required)
• Repressed elements to prevent hot spots at tubular bends

Optional Equipment

1. Alternate watt density (please specify) to suit specific fluid requirements
2. Alternate material construction
3. Alternate flange rating
4. Built-in thermostat 60-250^oF range
5. Built-in thermowell
6. Factory installed nonferrous baffle system
7. Passivation
8. Electropolished finish for high purity
9. Terminal hermetic seals
10. Military spec conformance to MIL-H-22577
11. Individually replaceable element blades
12. Welded elements
13. Dry side extended cold end

Hot Water Heaters Home | Hot Water Heaters Selection Guide | Rep Listing | Contact Hubbell Heaters

Low Capacity Electric Water Heaters | High Capacity Electric Water Heaters | Special Purpose Water Heaters | Steam Fired Water Heaters | Indirect / Direct Fired Water Heaters | Heating Elements & Coils