Water Heaters
 
Electric Hot Water Heater Diagram
PC Number Description
1 Hydrastone cement Lined Tank
2 3" Polyurethane Foam Insulation
3 Corrosion Resistant Jacket
4 Air Vent Valve
5 Relief Valve Connection
6 Dial Temperature Pressure Gauge
7 Hi-Limit Thromstat
8 Mixing Valve
9 Tepid Water Outlet
10 Tank Operationg Thermostat
11 Heating Element(s)
12 Cold Water Inlet
13 Drain Connection
General Characteristics
_________ Gallon Storage Capacity
_________ Total KW Rating
_________ Volts
_________ Phase
_________ Hertz
_________ Mixing Valve Set Temperature
_________ Full Load Amperage
_________ Cold Water Inlet Size
_________ Tepid Water Outlet Size
_________ Dry Weight (Lbs.)
_________ Wet Weight (Lbs.)

Notes:

  1. Storage tank rated for 150 psi WP.
  2. ASME rated T&P relief valve factory installed and piped to 12" from floor.
  3. All electrical controls are factory wired and tested.
  4. Mixing valve (pc. 8) is factory set, calibrated and tested to deliver 85 F Water.
Hubbell Electric Water Heater Company
 

Hot Water Heaters Home | Hot Water Heaters Selection Guide | Rep Listing | Contact Hubbell Heaters | Low Capacity Electric Water Heaters | High Capacity Electric Water Heaters | Special Purpose Water Heaters | Steam Fired Water Heaters | Indirect / Direct Fired Water Heaters | Heating Elements & Coils

Hubbell Heaters w The Electric Heater Company wP.O.Box 288 w Stratford, CT 06615-0288
Phone: (203) 378-2659 w Fax:(203) 378-3593 w Email: info@hubbellheaters.com