Provide
a quantity of __________ electric booster water heater(s)
Model No. __________ as manufactured by Hubbell The Electric
Heater Co. of
Stratford,
CT to supply the final 180°F sanitizing rinse water to
the dishwasher. The pressure vessel shall be all stainless
steel welded construction and shall bear the ASME Section VIII
stamp and be rated for 150psi WP. The tank shall be insulated
with rigid polyurethane foam insulation to reduce standby heat
loss. To minimize operating expenses, heat loss shall not exceed
425 btu/hr. The booster heater shall have the capacity to heat
__________ GPH from to __________ °F and shall be rated
at__________ KW when supplied with __________ volts, __________
phase.
The
booster shall be listed and approved in accordance
with UL Sanitation (NSF5) and UL1453. All controls shall
be built-in and factory wired. The booster shall include
internal
resettable circuit breakers in lieu of one-shot power fuses
for over current protection when required. The immersion
heating elements shall be high quality screw plug type
with O-ring
gasket to ensure leak free long life service. All temperature,
hi-limit, and low water operating functions shall be controlled
by a solid state device that shall provide the operator
with visual indication of fault conditions. For ease of
service
for any replaceable component, the positioning of all components
shall be such
that to remove any component does not require
the removal of another component. The booster shall be complete with all
internal plumbing, including 3/4" NPT connections for inlet, outlet, and relief valve.
The
entire exterior of the booster heater including the base,
jacket and front cover shall be brushed 304 stainless steel
for maximum corrosion resistance,
longevity and appearance. Painted steel exterior will not be considered as
equal.
The
booster heater shall include an ASME/AGA rated combination
temperature and
pressure relief valve, 6" adjustable NSF plastic legs (Optional Specification:
slide brackets on J6 model only), bronze body pressure reducing valve with
built-in bypass, and one indicating temperature and pressure gauge. Cast iron
pressure
reducing valves will not be accepted as equal.
In
addition, this packaged system shall be supplied with the
following optional features:
1.
Option ________________________
2.
Shock Absorber
3.
Floor Mounting Hardware
4.
Tamper Resistant Package
5.
Nickel Plated Die-Cast Leg
6.
Alternate Voltage
7.
Water Treatment System
The
entire pressure vessel shall be
provided with a full ten (10) year Non Pro-Rated tank
warranty. A ten year
pro-rated warranty shall not be considered as equal.
The entire
booster heater including
all components shall be provided with a one-year warranty
including parts and labor.
|
